1·The maximum allowable value for a semaphore would be exceeded.
信号量允许的最大值已经超过了。
2·When the heat dissipation is considered, the local temperature can still exceed the allowable value for the service of steel bolt.
考虑散热后，螺栓结构仍有部分区域的温度超过了材料的可用温度范围。
3·In installation, the positioning axis of the foundation and the bearing steel cylinder elevation exceed the allowable value of the standard deviation.
在安装方面上，基础的定位轴线和支承钢柱面标高超过规范允许偏差值。
4·Operation, the test units, request frequently condition in temperature, pressure, motor rated current more than the allowable value should be the emergency stop.
运行中，要求经常检测机组状况，在温度、压力、电机额定电流等超过允许值时应紧急停车。
5·High anti-scale efficiency. The maximum allowable value of LSI index in original water is 2.8, and it can control inorganic scales effectively within this range.
阻垢效能高，原水lsi指数最大允许值为2.8，在此范围内可有效的控制无机物结垢。
6·It is also found that there exists a maximum isolation period, at which, the limit ratio is zero or the horizontal displacement of the rubber bearing exceeds the allowable value.
研究还发现，存在一个最大的隔震结构周期使高宽比限值等于零或隔震层位移超过容许值。
7·It is also found that there exists a maximum isolated structure period at which the height width ratio is zero or the displacement of the rubber bearing exceeds the allowable value.
研究还发现，存在一个最大的隔震结构周期使高宽比限值等于零或隔震层位移超过容许值。
8·Now, if you run the form, you'll still see the alert box, but only once, because the new value is allowable according to the schema.
这时再运行表单，我们仍然会看到警示框，不过它只会出现一次，因为根据模式新值是允许输入的。
9·New value is outside the allowable range of values defined for this attribute.
新值不在为此属性定义的值的允许范围内。
10·The obtained lowest allowable flowing pressure value can be used as an important basis for allocation and design of an oil field.
得到的最低允许流动压力数值可作为油田配产和油田规划设计的重要依据。
1·Operation, the test units, request frequently condition in temperature, pressure, motor rated current more than the allowable value should be the emergency stop.
运行中，要求经常检测机组状况，在温度、压力、电机额定电流等超过允许值时应紧急停车。
2·High anti-scale efficiency. The maximum allowable value of LSI index in original water is 2.8, and it can control inorganic scales effectively within this range.
阻垢效能高，原水lsi指数最大允许值为2.8，在此范围内可有效的控制无机物结垢。